Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Dovetail Screw-Jaw Connector Pinning Vise
This bench vise holds JST-XH, JST-PH and Dupont connector housings square while you push crimped pins in. It has a 42 mm wide sliding jaw that prints in place in a 45° dovetail with 0.5 mm clearance, and one M3 x 25–30 screw with a captured hex nut pushes it closed. The jaw opening runs from 0 to 16 mm, so it doesn't rely on any one housing size. Housings up to 40 mm long sit face-down on the bench between the jaws.
Dupont 1-6 Pin Housing Sort Tray
A 123 x 94 x 22 mm bench tray with 12 bins for 2.54 mm Dupont/JST-style housings. Bin widths grow with pin count, from 11 mm for 1-pin to 26 mm for 6-pin. The front row holds male housings (marked with round dimples) and the middle row holds female housings (marked with square dimples). Two 25 mm troughs at the back take loose crimp pins, so you don't have to dig through the kit bag for a 3-pin female mid-build. Every bin has a 45° scoop ramp at the front to make small parts easy to pick out.
GX12 Panel Flange With Strain Relief
A 52 x 36 x 4 mm bolt-on flange that gives a GX12 aviation connector a proper 12.4 mm mounting bore with an 18 mm nut counterbore, so you can add a connector to a project box — or cover a ragged, oversized 15–24 mm hole — instead of epoxying the connector in. Four M3 clearance holes on a 42 x 26 mm pattern hold it to the panel, and the 16 mm gusseted post behind it has a zip-tie slot and a 8 mm cable saddle so a yank on the loom loads the plastic, not your solder joints.