Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Upright LiPo Charging Bag Stand
An open-window sleeve that holds a soft fireproof LiPo charging bag upright and open. The bag sits in a 72 x 48 mm well, its mouth folds over the 125 mm high rim, and the balance and charge leads leave through an 18 mm notch at the front. The 120 x 90 mm base has two 4.5 mm holes for #8 or M4 screws, so you can fix it to the bench and stop the bag sagging shut or tipping over while it charges.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
FPV Prop Roller Balancer With 624 Bearings
A propeller balancing stand for 5 mm-bore FPV and multirotor props up to 6 in (152 mm). Each upright holds a pair of 624 bearings (4 x 13 x 5 mm) on M4 screws, set one per face with 11 mm between centres so they overlap into a low-friction V. A 5 mm steel arbor rod through the prop rolls in that V until the heavy blade swings to the bottom. The arbor sits 82 mm above the base. The 110 x 60 mm footprint has a groove along one edge to park the rod.
FPV Belly-Mount Battery Skid Shoe
This sacrificial skid shoe fits under the battery on belly-mount FPV quads. You don't need to drill anything because the battery strap you already use holds it on. The strap runs through 22 mm tunnels and edge notches, which fit standard 20 mm straps on any LiPo up to 44 mm wide. The 84 x 44 x 7 mm plate has three ramped runners that take the scrape on hard landings, so the battery wrap and frame plate stay clean.
Flagged: battery or DC power. Not for safety-critical use without independent engineering review.
FPV Stack 30.5 To 20 mm Deck
A 46 mm square, 3.2 mm thick adapter deck that bolts to a frame drilled for the 30.5 x 30.5 mm M3 standoff pattern and carries a 20 x 20 mm M2 flight-controller / ESC stack on four 7 mm posts, lifting it 6.5 mm clear of solder pads and motor wires. A 16 mm centre window passes the battery and ESC leads, two 12 x 3 mm slots take zip ties, and 7 mm scallops in each side edge route wires off the plate; M3 holes are 3.4 mm and M2 bores 2.4 mm so the screws actually drop through.
Dual SMA Bulkhead Antenna Mount
A two-position bulkhead bracket for SMA / RP-SMA panel connectors: two 6.6 mm bores on 24 mm centres through a 4 mm deck, so a standard 6.35 mm bulkhead jack and its nut land flat with the antennas vertical. Gusseted L-frame, 54 x 44 x 44 mm, bolts down through four M4 clearance holes on a 42 x 30 mm pattern, with a pair of 3.2 mm zip-tie slots that take pigtail strain off the connectors — a replacement for the snapped antenna mount on FPV goggles, ground stations and receiver boxes.