Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Wago 221 Three-Bay Zip-Tie Carrier Plate
Screw-down carrier that stops loose Wago 221 lever connectors rattling around in LED-strip, van and RV low-voltage wiring. Three 32 mm wide bays each take any 2-, 3- or 5-way lever nut up to 32 mm wide; a 6 x 3 mm transverse groove runs under each bay so a standard 4.8 mm zip tie passes beneath the connector and cinches it down, and a second groove in the 13 mm cable strip beyond the bays ties the outgoing wires down for strain relief. Four 4.5 mm holes on a 117 x 22 mm pattern take M4 or #8 screws; plate is 126 x 47 x 8 mm.
Crimp Terminal Gauge Sort Tray
A 148 x 100 x 28 mm tray with 12 bins (34.6 x 30.7 mm each) for sorting crimp terminals. The four columns hold ring, fork/spade, quick-disconnect and butt-splice terminals, and the three rows follow the standard insulation colours: red 22–18 AWG, blue 16–14 AWG, yellow 12–10 AWG. Each row has 1, 2 or 3 dots recessed into the side wall so you can find a gauge at a glance. A 45° ramp at the front of every bin lets you slide a single terminal out with a fingertip.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.
Split Loom V-Saddle Screw Mount
A one-size screw-down saddle for routing split-loom wire harnesses. Its 90° V-cradle is 20 mm wide and 10 mm deep and centres any loom from 6 to 25 mm OD. Two 5.5 x 2.4 mm tunnels under the cradle take zip ties to strap the loom down, so you don't need a multi-pack of P-clips to get the one size you want. The footprint is 60 x 40 x 16.5 mm. The two 4.5 mm holes on 44 mm centres take #8 wood screws (4.2 mm shank) or M4 bolts, for car, boat, garage or control-panel wiring.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.