Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Wago 221 Three-Bay Zip-Tie Carrier Plate
Screw-down carrier that stops loose Wago 221 lever connectors rattling around in LED-strip, van and RV low-voltage wiring. Three 32 mm wide bays each take any 2-, 3- or 5-way lever nut up to 32 mm wide; a 6 x 3 mm transverse groove runs under each bay so a standard 4.8 mm zip tie passes beneath the connector and cinches it down, and a second groove in the 13 mm cable strip beyond the bays ties the outgoing wires down for strain relief. Four 4.5 mm holes on a 117 x 22 mm pattern take M4 or #8 screws; plate is 126 x 47 x 8 mm.
ATO Fuse Tap Zip-Tie Dash Mount
A small cradle that stops an add-a-circuit fuse tap dangling behind the fuse box. A U-channel with a 16 mm inner width holds the tap body and two bridged tunnels in the floor take zip ties up to 5 mm wide. A 3.6 mm comb slot gives the pigtail wire strain relief, and one 4.5 mm hole takes an M4 screw or a #8 (4.2 mm) sheet-metal screw. It is 62 x 24 x 15 mm overall.
Crimp Terminal Gauge Sort Tray
A 148 x 100 x 28 mm tray with 12 bins (34.6 x 30.7 mm each) for sorting crimp terminals. The four columns hold ring, fork/spade, quick-disconnect and butt-splice terminals, and the three rows follow the standard insulation colours: red 22–18 AWG, blue 16–14 AWG, yellow 12–10 AWG. Each row has 1, 2 or 3 dots recessed into the side wall so you can find a gauge at a glance. A 45° ramp at the front of every bin lets you slide a single terminal out with a fingertip.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.
Split Loom V-Saddle Screw Mount
A one-size screw-down saddle for routing split-loom wire harnesses. Its 90° V-cradle is 20 mm wide and 10 mm deep and centres any loom from 6 to 25 mm OD. Two 5.5 x 2.4 mm tunnels under the cradle take zip ties to strap the loom down, so you don't need a multi-pack of P-clips to get the one size you want. The footprint is 60 x 40 x 16.5 mm. The two 4.5 mm holes on 44 mm centres take #8 wood screws (4.2 mm shank) or M4 bolts, for car, boat, garage or control-panel wiring.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Trailer 4-Flat Plug Frame Holder
A frame-mounted saddle that parks a 4-flat trailer wiring connector pins-down so it drains instead of dragging: 84 x 30 mm base with two 5.5 mm M5 clearance holes on 54 mm centres plus two 4 x 12 mm zip-tie slots so it can strap to a round frame tube instead of being drilled. The 26 mm wide x 20 mm deep U-cradle takes the plug body with two 3.4 mm zip-tie slots across the front for retention, and a 10 mm cable channel with its own tie slot above the cradle acts as the strain relief the factory hanger never had. 66 mm tall, gusseted into the base so the load runs through the ribs, not across layer lines.