Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place Quarter-Turn Cam Latch
A quarter-turn cam latch that prints as one piece with a captive rotor — no pin, screw or spring to add. The 56 x 40 x 4 mm plate screws to a door or access panel with two countersunk #8 (4.2 mm) or M4 screws 22 mm apart, and the thumb knob turns a cam reaching 32.5 mm from the spindle axis, 10.5 mm past the plate edge, to hook behind a frame lip up to 9 mm proud of the mounting face. Moulded posts hard-stop the sweep at 90° and a detent bump snaps the cam into the open position so it stays clear; overall height 19 mm.
Hole-Free PCB Edge Clamp Carrier
A 92 x 54 mm carrier plate that mounts bare PCBs with no mounting holes — the fixed rail and a print-in-place dovetail jaw grip the board edges with 1.2 mm retaining lips, covering board widths from 11 to 65 mm of standard 1.6 mm FR4. The jaw locks with an M3 screw into a heat-set insert (4.0 mm bore) that jacks the dovetail tight, and the plate has four M3 clearance holes plus two zip-tie slots for cable strain relief.