Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place Hinged Pinch Collar For 3/4 in EMT
A clamshell stop collar for 3/4 in EMT conduit (23.4 mm OD) that prints in one piece with its 5 mm hinge pin already in place. It swings open so you can snap it on partway along a rail, then one M5 bolt and a captive M5 nut pull the 2 mm pinch gap closed. You don't have to slide anything over the pipe end. It is 16 mm tall with a 37 mm OD body, has a 23.6 mm bore and is 56 mm long overall. Use it as a height stop, a rail end-stop or an anchor point on EMT.
Rod-Clamp Station Pointer Collar
This part is for the 'NEMA17 Geneva Indexing Turntable' kit. The collar clamps to the top of the fixed 8 mm rod through an 8.3 mm bore, with an M3 set screw and a captured M3 nut. Its OD 11.4 × 4.5 mm pad holds the upper 608 bearing's inner race in place. The collar is 22 mm across and 14.5 mm tall. A 60 mm pointer arm ends in a 60° arrow that sits over the platter's r = 50 mm stations.