Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place 25 mm Webbing Cam Buckle
A print-in-place cam buckle for 25 mm (1 in) webbing. It replaces the cracked buckle on a tie-down, roof-rack or tote strap that is normally only sold as a whole strap. A toothed eccentric cam pivots on 5 mm integral stubs in 6 mm cheek bores, closing a 1.5 mm strap gap down to about 0.6 mm, and the fixed end loops round a 10.5 mm slot behind the bar. The buckle measures 35 x 53 x 21.5 mm.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Print-In-Place Rope Cam Cleat
A three-piece print-in-place cam cleat that jams 4–8 mm rope or paracord one-way for tarps, roof racks, awnings and van-life tie-downs — pull to tension, lift the line out to release. Base is 76 x 54 x 16 mm with four 5.5 mm M5 clearance holes on a 60 x 42 mm rectangle; the two toothed cams ride on 6 mm printed pins with retaining heads and are closed by 1.2 mm curved flexure springs, with 4.5 mm guide ribs fairleading the line in.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.