Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place 25 mm Webbing Swivel
A print-in-place swivel that joins two 25 mm (1 in) webbing loops and lets the strap spin freely, so a dog lead, tie-down or gear lanyard stops twisting up. Both slots are 27 x 6 mm. A 14 mm biconical head turns inside an octagonal hub with 0.5 mm clearance and takes the load on a 45° cone along the print plane. The part is 68 x 36 x 20 mm and prints with no supports.
Print-In-Place 25 mm Webbing Cam Buckle
A print-in-place cam buckle for 25 mm (1 in) webbing. It replaces the cracked buckle on a tie-down, roof-rack or tote strap that is normally only sold as a whole strap. A toothed eccentric cam pivots on 5 mm integral stubs in 6 mm cheek bores, closing a 1.5 mm strap gap down to about 0.6 mm, and the fixed end loops round a 10.5 mm slot behind the bar. The buckle measures 35 x 53 x 21.5 mm.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Side-Release Buckle For 20 mm Webbing
A print-in-place side-release (Fastex-style) buckle for 20 mm / 3/4 in webbing, printed already buckled — two sprung barb legs snap into windows in the female rails, press both sides to release. Overall 76 x 27 x 8.5 mm, with 21 x 3.5 mm webbing slots in both halves and 0.5 mm clearance on every mating face. Replaces the snapped buckle on a backpack, dog collar, tool bag or ratchet strap when the original is unobtainable.