Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place 25 mm Webbing Swivel
A print-in-place swivel that joins two 25 mm (1 in) webbing loops and lets the strap spin freely, so a dog lead, tie-down or gear lanyard stops twisting up. Both slots are 27 x 6 mm. A 14 mm biconical head turns inside an octagonal hub with 0.5 mm clearance and takes the load on a 45° cone along the print plane. The part is 68 x 36 x 20 mm and prints with no supports.
Print-In-Place 25 mm Webbing Cam Buckle
A print-in-place cam buckle for 25 mm (1 in) webbing. It replaces the cracked buckle on a tie-down, roof-rack or tote strap that is normally only sold as a whole strap. A toothed eccentric cam pivots on 5 mm integral stubs in 6 mm cheek bores, closing a 1.5 mm strap gap down to about 0.6 mm, and the fixed end loops round a 10.5 mm slot behind the bar. The buckle measures 35 x 53 x 21.5 mm.
Flagged: lifting or tensioned load. Not for safety-critical use without independent engineering review.
Hot Tub Cover Strap Ladder-Lock Anchor
A screw-on tie-down anchor for a hot tub cover. It replaces the snapped plastic strap clip with a two-slot ladder-lock cam bar for 25 mm (1 in) webbing, so you don't have to buy the whole strap. The plate is 52 x 80 mm and sits on two 6 mm stand-off rails, so the strap can run behind it. It mounts to the spa skirt with four #8 pan-head screws through 4.6 mm holes.
Under-Sink Filter Housing Strap Wrench
This strap-wrench handle takes a loop of standard 25 mm (1 in) nylon webbing, so it fits seized under-sink and RO filter housings of any diameter, stuck jar lids and canister tops. You don't need the brand-specific plastic spanner that came in the box. The handle is 172 mm long and the head is 48 x 32 mm. The webbing is anchored with an M5 x 35–40 bolt in a captive nut pocket and runs back through a 26.5 x 4 mm return slot. A 28 mm-wide V nose keeps the head centred on the housing.
Lawn Chair Webbing End Anchor Clip
This clip replaces the broken end clip on the webbing of a folding aluminium lawn or camp chair. The frayed end of a 1 in (25 mm) strap up to 2 mm thick goes through a 27 x 2.4 mm slot. Two M3 self-tapping screws pinch the strap, and a #8 screw passes through the 5 mm centre hole into the tube. A 90° V-saddle on the back sits square on frame tubes about 19–32 mm across. The block is 36 x 22 x 34 mm, so a chair that is otherwise fine can be reused.
Side-Release Buckle For 20 mm Webbing
A print-in-place side-release (Fastex-style) buckle for 20 mm / 3/4 in webbing, printed already buckled — two sprung barb legs snap into windows in the female rails, press both sides to release. Overall 76 x 27 x 8.5 mm, with 21 x 3.5 mm webbing slots in both halves and 0.5 mm clearance on every mating face. Replaces the snapped buckle on a backpack, dog collar, tool bag or ratchet strap when the original is unobtainable.