Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Steel-Pinned Print-In-Place Knuckle Link
A two-link knuckle joint that prints already assembled: a 12 mm tongue turns on a 10 mm printed pin between clevis cheeks, with 0.5 mm clearance all round. The pin has a 4.1 mm bore, so you can push a 4 mm steel dowel through it for extra stiffness. Each 24 x 8 mm arm has four M3 clearance holes on a 10 x 12 mm pattern for bolting to robot arms, legs or linkages, and the tongue's fillet acts as a hard stop when the link is straight.
Ackermann Steering Knuckle Upright
A steered-wheel upright for rover and RC-scale robot chassis: a 34 mm tall post with a 5.3 mm kingpin bore (5 mm dowel or M5 bolt), a 20 mm deep 8.3 mm socket for an 8 mm stub axle locked by an M3 grub screw in a 4.0 mm heat-set boss, and an Ackermann tie-rod arm with a 3.4 mm M3 hole 32 mm from the kingpin, angled inboard. Overall 46 x 44 x 34 mm; mirror it in your slicer for the opposite side.