Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Hinged SMD Stencil Paste Jig
A print-in-place hinged jig for applying solder paste through an SMD stencil: the 95 x 80 mm base deck has a 70 x 50 mm pocket 1.6 mm deep that holds a standard FR4 board flush with the deck, and a 95 x 62 mm frame folds over on a 5 mm print-in-place hinge so the stencil stays registered while you squeegee. Two 11 mm ejection holes push the finished board out from below, and two M3 clearance holes tie the jig down to the bench.
Axial Lead Bending Pitch Jig
A 136 x 26 x 14 mm bench jig for forming the leads of axial through-hole parts (1/4 W resistors, diodes, small caps) to exact PCB hole pitch: lay the body across a rib, press both leads down the sides, and the lead centres land on the 2.54 mm grid. Six ribs give 5.08, 7.62, 10.16, 12.7, 15.24 and 20.32 mm (0.2–0.8 in) pitches — each rib is milled 0.6 mm under its pitch so the bent lead diameter makes up the difference — with 3 mm relief slots through the 4 mm base so long leads pass clear, and two M3 clearance holes 122 mm apart for bolting it to the bench.
Slide-Jaw PCB Soldering Vise
A print-in-place PCB soldering vise: a 110 x 38 x 8 mm base rail with a captive T-slot jaw that slides along it, holding boards from 15 mm to 79 mm wide in a pair of 2.6 mm edge grooves (sized for 1.6 mm FR4). An M4 self-tapping screw through the sliding jaw jacks against the rail floor to lock it; four 4.5 mm M4 clearance holes bolt the rail to a bench or plate.