Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Radius Corner Rounding Template
A 100 x 100 x 4 mm hooked template with a different corner on each side: 1/4 in (6.35 mm), 1/2 in (12.7 mm), 3/4 in (19.05 mm) and 1 in (25.4 mm). Hook the 6 mm fence lips over the corner of a board or panel, then trace or flush-trim the arc so every corner of a shelf, lid or plate comes out the same. Through-holes next to each corner (one dot for the smallest radius, four for the largest) tell you which radius you're on.
Twin-Lane 1-20 mm Setup Block
This stepped setup gauge has two lanes. One lane has even heights from 2 to 20 mm and the other has odd heights from 1 to 19 mm, so every whole millimetre from 1 to 20 is covered on a block about 80 x 24 mm. Use it to set router bit height, table-saw blade height, fence offsets and depth stops in one touch instead of with a ruler. There is a 5 mm hang hole in the tallest step.