Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Desktop Pegboard Upright Clamp Foot
A pair of these feet holds a 1/4 in (6.35 mm) or 1/8 in hardboard pegboard panel upright on a desk, so you can hang tools without drilling the wall. Each foot is 140 x 64 mm with a 6.8 mm wide, 32 mm deep gusseted slot. An M4 thumbscrew in a 5.5 mm heat-set insert bore clamps any board from 3 to 6.8 mm thick, and four 4.6 mm holes take #8 screws if you want to fix the foot to the desktop.
Under-Desk PC Tower Corner Riser Foot
A 64 x 64 mm corner foot that raises a desktop PC tower 25 mm off the carpet under your desk. The case bottom sits on a flat 3 mm deck, and a 4 mm thick, 10 mm tall braced L-lip holds the corner so the case can't slide off. Because it only holds the corner, it fits any tower width or depth. Print four. The inside is a 3 x 3 grid of open cells, so it uses about 40 cm³ of plastic and prints without supports.