Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Desktop Pegboard Upright Clamp Foot
A pair of these feet holds a 1/4 in (6.35 mm) or 1/8 in hardboard pegboard panel upright on a desk, so you can hang tools without drilling the wall. Each foot is 140 x 64 mm with a 6.8 mm wide, 32 mm deep gusseted slot. An M4 thumbscrew in a 5.5 mm heat-set insert bore clamps any board from 3 to 6.8 mm thick, and four 4.6 mm holes take #8 screws if you want to fix the foot to the desktop.
Under-Desk PC Tower Corner Riser Foot
A 64 x 64 mm corner foot that raises a desktop PC tower 25 mm off the carpet under your desk. The case bottom sits on a flat 3 mm deck, and a 4 mm thick, 10 mm tall braced L-lip holds the corner so the case can't slide off. Because it only holds the corner, it fits any tower width or depth. Print four. The inside is a 3 x 3 grid of open cells, so it uses about 40 cm³ of plastic and prints without supports.
Biped Rolling Foot Plate
Black 90 x 58 x 3 mm foot sole with a 36 mm wide, 6 mm thick horn upright, part of the 'SG90 Parallelogram-Leg Biped Walker' kit. An SG90 horn fits flat against the rear face, with its hub in a 5.5 mm vertical slot. Two M2x10 self-tapping screws go through 2.4 mm slots (r = 5–16 mm), which come in three rows at 30, 34 and 38 mm above the sole for height adjustment. The ankle block has space to roll ±20° behind the upright. Print two, one mirrored in Y.
Bolt-On Ladder Rail Foot Cap
Replacement foot cap for aluminium step and extension ladders with 40 x 20 mm rectangular leg tubing — it slips over the rail end (40.6 x 20.6 mm socket, 27 mm deep) and is held by an M5 bolt through the rail instead of glue, with two 5.5 mm hole heights (14 mm and 24 mm above the ground) so you can reuse the original rivet hole. The 52 x 32 x 7 mm pad has 3 mm deep tread grooves and a 5 mm centre drain, total height 34 mm.
RV Awning Pole Ground Foot
A 76 mm wide ground foot that stops an RV awning or canopy pole from sinking into dirt, gravel or grass. The 57 mm socket takes a 1 in (25.4 mm) pole end down to a 7/8 in (22.2 mm) step, each with a 5.5 mm cross hole for an M5 bolt or clevis pin, and three 5.5 mm stake bosses at a 60 mm circle let you peg or screw it down.