Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Slotted Triangular Desk Credenza Foot
This is a 75 mm tall tapered triangular foot that screws onto desk credenzas, desk pedestals, media consoles and TV stands. It replaces a mid-century-style foot that has snapped off and is no longer sold. The 94 mm triangular flange has three radial slots, 4.8 mm wide by 7 mm long, for #8 (4.2 mm) wood screws, so it can line up with old pilot holes. The hollow 2.5 mm-wall leg narrows from a 48 mm to a 35 mm triangle and ends in a 16 mm × 2 mm recess for a stick-on felt or rubber bumper.
Monitor Arm Zip-Tie Cable Saddle
A 34 x 30 x 36 mm cable saddle that replaces the snap-on cable covers that break off monitor arms. A 90° V-notch underneath sits on round arm tubes about 18–50 mm across or on flat-topped arms, and two 2.2 x 5.5 mm tunnels take standard zip ties up to 4.8 mm wide to strap it down. On top there are three snap-in channels: one 8.2 mm bore for an HDMI or DisplayPort cable and two 6.2 mm bores for USB-C or power leads, each with a mouth 1.2 mm narrower than its bore so the cable clicks in.
Office Chair Caster Stem Glide Foot
Fixed glide foot that drops into an office chair base in place of a rolling caster, for the standard 7/16 in x 7/8 in (11 x 22 mm) grip-ring stem socket; the 10.2 mm stem carries four crush ribs to 11.4 mm so it presses tight into 11.0–11.3 mm sockets (not 10 mm Euro stems). The 50 mm diameter, 14 mm tall pocketed foot has a flat bottom for a stick-on felt pad and a 36 mm overall height; print five to stop a chair rolling on hard floors.
Stick-On Flip-Out Keyboard Tilt Foot
This replaces a snapped or lost keyboard tilt leg. It sticks under any keyboard with VHB tape and gives two heights: folded, the 12 mm heel block holds the keyboard up; flipped out, the 29 mm wide leg stands 20 mm tall and rests against a stop. The whole foot is 40 x 32 x 12 mm and prints in place as one piece, with a 4 mm pin in a 4.9 mm bore (0.45 mm radial clearance). Print one for each side.
Slotted 64-96 mm Desk Drawer Pull
This is a 130 x 34 x 18 mm replacement bar pull for desk drawers and file cabinets that lost a handle whose exact hole spacing nobody sells anymore. Each foot has a 4.5 mm slot with a sliding M4 nut channel (7 mm across flats) behind it, so one pull fits any centre spacing from 64 to 96 mm, including 64 mm, 3 in (76.2 mm), 3.5 in (88.9 mm) and 96 mm. It prints on its side, so pulling on the handle loads it along the layers instead of across them.