Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
ANL Fuse Holder Slotted Riser Plate
A 150 x 54 mm riser plate for bolting an ANL/MIDI fuse holder or small distribution block under a seat or in a trunk. The holder doesn't need to have any particular hole spacing: an 80 mm M5 slot along the 9 mm rail has a hex-nut channel underneath, so both bolts can slide anywhere from 0 to 80 mm apart. Four 4.5 mm holes take #8 or M4 screws into the floor, and a zip-tie saddle at each end holds power cable up to about 13 mm OD so the leads can't work the holder loose.
50 mm Flared Bass Reflex Port Tube
Screw-in bass-reflex port for car-audio and home speaker boxes: 50 mm bore, 100 mm long, 45° flares at both ends, on a 96 mm flange. Drill a 73 mm (2-7/8 in) hole-saw hole in the baffle, then fix the port with four #8 wood screws through 4.8 mm clearance holes on an 84 mm circle. No more routing MDF ports, and it prints upright with no supports.