Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Screw-Clamp Breaker Handle Lockout
A clamp-on lockout for single-pole breakers. It fits over the toggle through a 10 mm channel, and an M4 screw in a brass heat-set insert clamps toggles 1–10 mm thick: use M4x25 for 1–7 mm and M4x20 for 6–10 mm. A padlock shackle up to 7 mm goes through the vertical hole and blocks the screw head, so nobody can loosen the clamp until the lock comes off. The body is 51 x 20 x 20 mm and fits within the 25.4 mm breaker pitch.
52 mm Gauge Pod Panel Mount
A single-hole pod for a standard 52 mm (2-1/16") boost, oil-pressure or volt gauge: Ø52.4 mm bore, 36 mm deep, stepping down to a Ø48 mm shoulder that stops the gauge and lets the harness exit straight through the base. The cup sits at 18° on a flat 92 x 78 x 5 mm plate with four M4 clearance holes (VHB-friendly underside), and two M4 heat-set inserts in the flank pads take nylon-tip set screws that lock the barrel — total height about 58 mm, prints on the plate with no supports.
Flagged: automotive electrical. Not for safety-critical use without independent engineering review.