Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
1/2 in EMT Curtain Rod Wall Bracket
A gusseted wall bracket for DIY industrial-style curtain rods made from 1/2 in EMT conduit (17.9 mm OD). The rod slips through an 18.4 mm bore and an M4 self-tapping set screw locks it in place. The bracket stands the rod 88 mm off the wall so it clears blinds and trim, and it fixes to the wall with two #8 wood screws through 5 mm holes. It prints on its side, so the rod's weight runs along the layers instead of across them. The bracket is 104 x 82 x 24 mm.
Curtain Rod Center Support Bracket
A wall bracket that stops a long curtain rod sagging in the middle: a 90° V saddle self-centers any rod from 16 to 28 mm OD (5/8" to 1-1/8") with the rod axis 45 mm off the wall, and two cable-tie slots break into the groove so one zip tie traps the rod against lift-out. The 6 mm wall plate takes two M4 (#8) screws on a 28 mm vertical spacing, the saddle is 18 mm wide along the rod, and the whole 64 x 44 x 18 mm part is a single vertical-walled prism that prints flat with no supports.