Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Swing-Arm Tote Lid Latch Retrofit
A pivoting latch that bolts to the side of a plastic storage tote with one M4 bolt and nyloc nut through a 4.5 mm clearance hole. Rotate the 90 mm arm upright and its hooked crossbar presses down on the lid rim, then swing it aside to open. It replaces broken or missing tote latches. The latch is 16 mm wide and has a 17 mm standoff boss, so it clears rims that stick out up to about 16 mm from the wall and sit 30–84 mm above the bolt.
M5 Screw Storage Tote Lid Rim Clamp
This C-clamp replaces the snap latch that cracks off Rubbermaid/Sterilite-style storage totes. The top jaw sits on the lid, and an M5 bolt or thumbscrew through a captive-nut lower jaw tightens up under the tub's rim flange. The 34 mm opening clamps any rim stack from about 3 to 30 mm, so you don't need to measure your tote. It is 50 x 30 x 20 mm, prints flat with the clamping load in the layer plane, and takes a standard M5 hex nut (8 mm across flats) plus an M5 x 30–40 bolt.