Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Barbed Screen Door Corner Key
This is an L-shaped internal corner key that rejoins the mitred aluminium rails of a screen door or window screen frame after the original key breaks. Each leg is 55 mm long, 15 mm wide and 5.6 mm thick. Angled flex barbs on the leg edges grip hollow channels 15.5–17.5 mm wide, and a 2.6 mm pilot hole in each leg takes a #6 or M3 self-tapping screw driven through the rail to lock it. Measure your channel before ordering. If it is shallower than 5.6 mm, sand the key's flat faces down until it fits.
Storm Door Insert Two-Reach Turn Button
A replacement turn button for the swing clips that hold glass or screen inserts in aluminum storm doors and windows. It is 56 x 16 mm and pivots on a #6/#8 or M4 screw through a countersunk 4.5 mm hole. The two arms reach different depths, 2 mm and 5 mm above the frame face. Turn whichever arm matches your insert onto the panel, and the chamfered edges ride up onto the panel as you turn it. No discontinued OEM clip is needed.
Storm Door Closer Jamb Bracket
Replacement jamb-side bracket for a pneumatic storm/screen door closer, so a cracked or pulled-out bracket doesn't force you to buy a whole closer kit and re-drill the jamb. The 84 x 34 x 6 mm back plate carries two 5 mm wide x 20 mm slots that cover 43-73 mm screw spacing (#8 wood screws) to land on the existing holes, and the stacked clevis ears give a 12 mm gap for the rod-end tab with a 5.5 mm vertical bore 16 mm off the jamb face for an M5 bolt or a 5 mm clevis pin and hitch clip.