Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Window Screen Push-In Pull Tab Set
A set of four replacement window screen pull tabs that push into the spline channel beside the rubber spline, replacing the vinyl tabs that crumble in the sun. Each tab is a 10 mm wide finger loop (15 mm outer diameter, 9.5 mm hole) on a 12 x 2.4 mm base that sits on the frame lips, with a 1.2 mm thick barbed leg in four lengths (5, 7, 9 and 11 mm) to suit shallow and deep channels around a 3.6 mm spline; the whole set prints flat on its side so layer lines run along the loop-to-leg bend and the tabs snap apart on 1 mm thick sprues.
Barbed Screen Door Corner Key
This is an L-shaped internal corner key that rejoins the mitred aluminium rails of a screen door or window screen frame after the original key breaks. Each leg is 55 mm long, 15 mm wide and 5.6 mm thick. Angled flex barbs on the leg edges grip hollow channels 15.5–17.5 mm wide, and a 2.6 mm pilot hole in each leg takes a #6 or M3 self-tapping screw driven through the rail to lock it. Measure your channel before ordering. If it is shallower than 5.6 mm, sand the key's flat faces down until it fits.
Storm Door Insert Two-Reach Turn Button
A replacement turn button for the swing clips that hold glass or screen inserts in aluminum storm doors and windows. It is 56 x 16 mm and pivots on a #6/#8 or M4 screw through a countersunk 4.5 mm hole. The two arms reach different depths, 2 mm and 5 mm above the frame face. Turn whichever arm matches your insert onto the panel, and the chamfered edges ride up onto the panel as you turn it. No discontinued OEM clip is needed.