Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Print-In-Place Hinged Pinch Collar For 3/4 in EMT
A clamshell stop collar for 3/4 in EMT conduit (23.4 mm OD) that prints in one piece with its 5 mm hinge pin already in place. It swings open so you can snap it on partway along a rail, then one M5 bolt and a captive M5 nut pull the 2 mm pinch gap closed. You don't have to slide anything over the pipe end. It is 16 mm tall with a 37 mm OD body, has a 23.6 mm bore and is 56 mm long overall. Use it as a height stop, a rail end-stop or an anchor point on EMT.
Dog Tie-Out Swivel Cap For 1/2 in EMT Stake
A print-in-place swivel head for a dog tie-out that slips over a 1/2 in EMT conduit stake (17.9 mm OD, 18.3 mm bore, 36 mm deep). It replaces the swivel eye that strips or snaps on corkscrew stakes, which are usually only sold as a whole kit. A 50 mm ring rides on a V-race with a 0.5 mm gap, so the 11 mm snap-hook eye turns a full 360° and the lead doesn't wind around the stake. The part is 45 mm tall, and the pull from the lead runs in the layer plane. There's an optional M4 self-tapping set-screw hole if you want to lock the cap onto the stake.