Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Slot-Adjust Print-In-Place Surface Cabinet Hinge
This surface-mount butterfly hinge prints in place. Each 64 x 28 x 3 mm leaf has a 9 mm five-knuckle barrel with a 5 mm pin running in a 6 mm bore, so the pin has 0.5 mm of clearance all round. It replaces discontinued non-Euro hinges on older face-frame cabinets. The 3.8 mm slots for #6 wood screws (3.5 mm shank) run lengthwise on one leaf and crosswise on the other, so you can line them up with the old screw holes instead of drilling new ones.
Hose Reel Spinning Crank Knob M5
This print-in-place crank knob replaces the snapped handle on a wall-mount or cart garden hose reel. The 29 mm grip spins freely on a core that is 66 mm tall. It bolts through the reel's existing crank arm with one M5 bolt. The bolt head sits deep in a 9.6 mm socket, so an M5 x 25–30 mm bolt is long enough. A captured M5 nut pocket (8.2 mm across flats) in the 30 mm base flange lets you run the bolt from either side. It isn't tied to any brand's handle shape, so a reel that still works can go back into service.
Stick-On Flip-Out Keyboard Tilt Foot
This replaces a snapped or lost keyboard tilt leg. It sticks under any keyboard with VHB tape and gives two heights: folded, the 12 mm heel block holds the keyboard up; flipped out, the 29 mm wide leg stands 20 mm tall and rests against a stop. The whole foot is 40 x 32 x 12 mm and prints in place as one piece, with a 4 mm pin in a 4.9 mm bore (0.45 mm radial clearance). Print one for each side.