Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Three-Hook Padlock Wall Ladder
A 176 mm tall wall-screwed spine with three lipped J-hooks spaced 58 mm apart, so padlocks, bike locks and key rings each hang on their own hook. The 8 x 6 mm arms fit any shackle with at least a 9 mm inner gap and give 27 mm of reach. It prints on its side so the hooks carry load along the layers, not across them, and it mounts with two #8 / M4 screws through 4.5 mm counterbored holes.
Cabinet Door Twin Cutting Board Holster
A screw-on holster for the inside of a cabinet door. It stores two cutting boards upright, each up to 20 mm thick, in two 22 mm drained pockets, and stands just 56 mm off the door. Print two (each is 30 mm wide by 90 mm tall) and space them under the boards. Mount with #6 wood screws (3.5 mm shank) or M4 screws through the 4.5 mm holes. The part prints on its side so every layer holds the full U profile, which keeps the board weight in the strong plane.
Six-Slot Fishing Rod Wall Rack
This is a 168 x 56 mm rack that screws to a garage wall and holds six fishing rods upright, with the butts resting on the floor. Each slot has a 17 mm keyhole pocket behind a 12 mm throat with a flared mouth, so a rod blank or ferrule up to about 16 mm sits in the pocket and lies back against the wall. It mounts with three #8/#10 wood screws or M5 screws through 5.5 mm holes, and the 6 mm arm is braced by four 45° gussets.
Desk-Side Screw-On Pen And Scissors Caddy
A caddy that screws to the side of a desk, pedestal or monitor shelf and keeps pens, scissors and a ruler within reach without using any desk space. It measures 124 x 25 x 42 mm and has two 13 mm pen wells, a 24 x 9 mm scissor-blade slot and a 34 x 4 mm ruler slot. Two side ears take #8 wood screws or M4 bolts through 4.6 mm holes.