Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Gridfinity 1x1 Four-Cell Half-Grid Bin
A standard Gridfinity 1x1 bin (41.5 x 41.5 mm, 3 units / 21 mm tall, no stacking lip) split into four 18 x 18 mm cells on a 21 mm half-grid pitch. Each cell has a 45° scoop ramp at the front. It gives desk and bench Gridfinity grids the finer sorting that SMD parts, small screws and connectors need, without moving to a non-standard baseplate.
12 mm Vial Stepped Rack With Pour Tray
A two-tier rack that holds twelve 12 mm OD screw-cap vials or small test tubes upright, one size of loose M2/M2.5 screws, washers or 0402/0603 passives per tube. The back row stands 12 mm taller so you can read the labels. The 12.8 mm bores have chamfered lead-ins, and a 26 x 100 mm pour tray in front lets you tip out a tube, pick what you need and pour the rest back. The rack is 104 x 74 x 36 mm and the sleeves are hollow to keep material low.
Four-Reel SMD Tape Wall Rack
A 150 x 32 mm wall plate with four 12.4 mm pegs on 30 mm centres that hang 7 inch (178 mm) SMD component reels by their 13 mm EIA-481 arbor hole, so you can pull tape one-handed at the bench. Pegs stand 36 mm proud on a tapered root and tilt 5 degrees upward so loaded reels stay put and clear the wall; four 4.5 mm holes take M4 or #8 wood screws, and a 10 x 3 mm slot under each peg pinches the tape end so the reel can't unwind.
Cut Tape SMD Strip Rack
A terraced 9-channel rack that stands loose cut-tape strips of SMD passives on edge so they stay readable and stop unspooling in a drawer. Channels are a uniform 4.6 mm wide (paper or embossed carrier) but stepped in depth — 5 mm for 8 mm tape at the front, then 7, 9 and 13 mm for 12, 16 and 24 mm tape at the back — so every strip protrudes by roughly half its width. Body is 144 x 65.4 x 16 mm, holds strips up to 117 mm long, with a 125 x 8 mm front face for a label strip and two M3 clearance ears (3.4 mm, 130 mm apart) to screw it to a shelf or bench back.