Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
M5 Bolt-Pivot Fan-Out Sort Tray Tier
A four-cell parts tray (126 x 64 x 22 mm) with a 20 mm pivot boss bored to 5.5 mm. Stack several on one M5 bolt and they fan out sideways like a tackle-box tower, so the cells you aren't using swing back out of the way. Each boss is 24 mm tall, which leaves a 2 mm gap between tray tiers. The whole stack bolts through to a bench or under a shelf, and you set the swing friction by how tight you run the M5 nut.
Three-Tier Cooling Rack Corner Tower
This is a corner tower. Print four of them and you can stack three wire cooling racks of any rectangular size above the counter, with 48 mm between levels. Each tower is an L-shaped post 154 mm tall with 50 mm arms and 10 mm ledges supported on 45° gussets. A wide L-shaped foot keeps it steady, and the walls on the outer sides stop the racks from sliding off.