Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Vertical Bike Wall Hook With Rim Saddle
Screw-on J-hook that hangs a bike vertically by its front wheel. The rim's spoke bed rests in a curved saddle 85 mm out from the wall, behind a lip 24 mm tall. It mounts to a stud with two #10 (4.8 mm) or M5 screws through countersunk 5.5 mm holes 105 mm apart. The part is 104 x 140 x 22 mm and prints on its side, so the bending load runs along the layers instead of across them.
Screw-On Ladder Rail Wall Hook
A heavy wall hook for hanging a ladder flat on the garage wall. It has a 92 mm deep cradle and a 32 mm retaining lip, so the side rail of a stepladder or a nested extension ladder drops in and can't roll out. Print two and fix each to a stud with #10 (4.8 mm) screws through 5.5 mm holes. It prints on its side, 150 x 112 x 22 mm, so the weight loads along the layers and the tapered truss arm keeps the plastic volume down.