Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
90/45 Chisel Paring Guide Block
A 100 mm long, hollow-ribbed guide block for paring with a chisel. Clamp it on the work and run the chisel's flat back down the dead-flat 90° face to trim tenon shoulders and dovetail baselines square, or down the 45° face to clean up mitres and chamfers. The profile is 60 x 40 mm, and the block is printed on its end so both guide faces come out as smooth, accurate perimeter walls with sharp reference edges.
Chisel Honing Guide With 625 Roller
A side-loading honing guide that holds a chisel or plane iron at a repeatable bevel angle on a waterstone or diamond plate: blades up to 52 mm wide and 2–8 mm thick slide into the 9 mm slot and are pinched flat by four M4 screws in heat-set inserts, while a 625 bearing (16 mm OD) rolls on an M5 bolt axle. Overall 66 x 40 x 33.5 mm; blade projection past the front face sets the angle — 38 mm ≈ 25°, 30 mm ≈ 30°, 23 mm ≈ 35°. Printed standing on its back face so every wall is vertical and the clamp beam never delaminates.