Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
90/45 Chisel Paring Guide Block
A 100 mm long, hollow-ribbed guide block for paring with a chisel. Clamp it on the work and run the chisel's flat back down the dead-flat 90° face to trim tenon shoulders and dovetail baselines square, or down the 45° face to clean up mitres and chamfers. The profile is 60 x 40 mm, and the block is printed on its end so both guide faces come out as smooth, accurate perimeter walls with sharp reference edges.
Five-Chisel Wall Rack With Separator Fins
This wall rack holds five bench chisels by the neck. Each chisel drops into an 11 mm U-slot from the front, the bolster rests on top, and the blade hangs into its own bay between separator fins. The bays are 28.8–29.6 mm wide, so blades up to 25 mm (1 in) can't swing into each other and chip an edge. The rack is 164 x 94 x 26 mm and hangs from four 5 mm holes for #8 (4.2 mm) wood screws.
Chisel Honing Guide With 625 Roller
A side-loading honing guide that holds a chisel or plane iron at a repeatable bevel angle on a waterstone or diamond plate: blades up to 52 mm wide and 2–8 mm thick slide into the 9 mm slot and are pinched flat by four M4 screws in heat-set inserts, while a 625 bearing (16 mm OD) rolls on an M5 bolt axle. Overall 66 x 40 x 33.5 mm; blade projection past the front face sets the angle — 38 mm ≈ 25°, 30 mm ≈ 30°, 23 mm ≈ 35°. Printed standing on its back face so every wall is vertical and the clamp beam never delaminates.