Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
120 mm Fan Standoff Finger Guard
A finger and wire guard for a bare 120 mm axial fan. It bolts on through the standard 105 mm square hole pattern with 4.5 mm holes that take fan screws or M4 bolts, and a 3 mm built-in standoff ring holds the concentric grille clear of the blades. The guard is 120 x 120 x 5 mm. The ring gaps are about 7.5 mm, small enough to keep fingers and loose leads out of a fan you've pulled for a DIY amp, PSU or rack build.
120 mm PC Fan Desk Stand
A tilted stand that turns a spare 120 mm PC case fan into a quiet desk fan or bench fume mover — the fan bolts to the 105 mm square pattern with 4.5 mm holes that take either the stock #6-32 fan screws or M4, and the frame leans back 20 deg so the air goes at your face rather than across the desk. Footprint 130 x 92 mm, 114 mm tall, with a windowed base, cored side gussets and a pair of 4 mm zip-tie slots at the rear to dress the fan lead.