Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Adjustable M5 Pin Spanner Wrench
This 170 x 24 x 8 mm adjustable pin spanner uses two M5 bolts as pins. One bolt is locked in a fixed hex-nut pocket. The other runs in a 70 mm slot with a captive sliding-nut channel underneath, which sets the pin spacing anywhere from 20 to 90 mm. Use it on two-hole lock rings, threaded caps, pool and spa strainer lids, bike lock rings and lens rings when you don't have a dedicated spanner for that one size. The bar prints flat, so the turning force runs along the layers, and there are notches every 10 mm for repeatable settings.
Micro Servo Slot Mount Plate
A 64 x 22 x 5 mm slotted servo carrier used at all four axes of the 'MG90S Animatronic Desk Lamp Robot' kit. It takes an MG90S or SG90 servo through a 22.8 x 12.6 mm window, with M2 screws through the tabs on a 27.8 mm pitch. Two rounded 3.4 mm M3 slots allow ±3 mm of travel on the kit's 44 mm heat-set insert pitch, so you can line up the spline on the joint axis even when a clone servo's tabs are a little off.
GPU Anti-Sag Ladder Column
A height-adjustable graphics card support brace: a 76 x 48 mm zip-tie base plate, an 84 mm hollow column with an eleven-rung M4 ladder on 6 mm pitch, and a print-in-place saddle that slides over the column and locks with a single M4 bolt into a captured nut. The 46 mm wide cradle pad has 3 mm retaining lips 21 mm apart to stop a heavy GPU from sagging or walking off the pad.