Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Air Blow Gun V-Slot Holster With Hose Hook
This wall station is 120 x 46 x 70 mm and screws up next to the compressor with three #8 pan-head wood screws (4.6 mm holes). Its tapered V-slot shelf takes any blow-gun or inflator nozzle from 9 to 24 mm wide, so the gun hangs nozzle-down and rests on the shelf. The coiled recoil hose hangs from a lipped hook with a 40 mm deep saddle. It prints upright with no supports: every underside is 45°, and the hook is a hollow triangle (open truss) to save plastic.
Air Fitting And Hose Coupler Sort Block
A 148 x 118 mm tray with 11 thread-down cups for loose brass fittings. There are four 15 mm cups for 1/4" NPT plugs and couplers (thread OD 13.7 mm), four 18.5 mm cups for 3/8" NPT (17.1 mm) and three 28 mm cups for 3/4" garden-hose GHT fittings (about 26.5 mm). The bores are oversize so slightly different brands still fit. Each fitting stands on its threads with the hex body sitting on a chamfered rim, so the drawer full of mixed couplers becomes one tray you can read at a glance.
Air Hose Wall Pass-Through Trumpet
This screw-on grommet fits a 1-1/2 in (38.1 mm) hole-saw hole. It lets an air line, shop-vac hose or extension cord pass through a garage wall or into a compressor closet without the hose rubbing on raw drywall or stud edges. The part has a 76 mm flange with three countersunk #8/M4 screw holes (4.5 mm) and a 28 mm bore that flares at 45° to 40 mm on the room side. A 25 mm crush-ribbed sleeve press-fits the hole.