Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Four-Tip Saw Bevel Setup Gauge
A 150 x 50 x 8 mm flat gauge for setting table-saw blade tilt, miter-saw bevels and miter-gauge angles. Each of its four sharp tips is a 22.5°, 30°, 45° or 60° reference, marked with 1 to 4 dimples. To check a setting, stand the gauge on edge against the blade instead of trusting the saw's worn bevel scale. It prints flat, so every reference edge is formed in the XY plane where an FDM printer is most accurate, and the bottom edge is chamfered to cut down elephant's foot.
EMT Conduit Pendulum Bend Angle Gauge
A pendulum protractor for checking conduit bends. Its 90° V-foot sits on 1/2" EMT (17.9 mm OD) or 3/4" EMT (23.4 mm OD) and is held on by a rubber band or zip tie through two slots. A swinging pointer, printed in place, reads ticks every 15° (longer ones at 0°, 45° and 90°) in either direction, so you can check 22.5°, 45° and 90° stub-up bends while the conduit is still in the bender. The part is 126 x 114 x 32 mm, and you can drop an M5 bolt and nut into the bob's 5.5 mm hole to add weight so the pointer settles faster.