Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Console Lid Snap Hook And Striker Set
A screw-in replacement latch for the centre-console armrest lid on older cars. A flexing barb hook mounts under the lid and snaps into a 5 mm striker window on the console wall. Both mount with #6/#8 screws: the hook through 4.5 mm holes 20 mm apart, the striker through vertical slots 23 mm apart for up to 4.5 mm of height adjustment. The pair prints as one flat 30 × 51 × 14 mm piece and snaps apart at thin breakaway tabs.
Office Chair Armrest Riser Spacer
A 20 mm ribbed spacer that sits between an office chair's armrest bracket and its pad to raise the armrest for taller users or a too-low chair. Footprint is 92 x 54 mm with a 7 mm wide, 74 mm long slot through both faces, so it takes M5, M6 or #10-24 chair screws at any spacing up to 67 mm apart — measure your pad screws first and buy screws 20 mm longer than stock. Hollow rib grid inside, flat contact faces both sides, stack two for 40 mm.