Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Tub Lip Screw-Clamp Draining Soap Ledge
A drill-free soap and razor ledge that clamps over the rim of a freestanding, clawfoot or drop-in tub. An M5 screw runs through a captured nut and closes on any rim from about 4 to 38 mm thick, with a 30 mm deep jaw. The 56 x 70 mm tray drains through twelve 4 mm holes, has a 15 mm front lip, and two gussets carry the load into the inner jaw. It prints flat on its side, so the clamp loads stay in the layer plane.
1/2 in PVC Over-Tub Caddy End Saddle
This end saddle turns two lengths of 1/2 in schedule 40 PVC pipe (21.3 mm OD) into a bath caddy that sits across the tub, sized to any tub once you cut the pipe to length. Each saddle has two 21.7 mm slip-fit sockets 27 mm deep on 70 mm centres, an M3 cross-pin hole to lock each rail, an 18 mm drop lip that hooks inside the tub wall, and a 30 mm deep pad that rests on the rim. Print two; each one is 104 x 52 x 32 mm.
Slotted Tub Trip-Lever Linkage Extender
This slotted strap fits between a bathtub overflow trip lever and the plunger or rocker linkage below it. It adds length when the stock kit won't reach on a deep tub. The strap is 120 x 12 x 5 mm with a spine. One end has two 4.5 mm pin holes 10 mm apart, and the other end has a 52 mm long M4 slot, so with an M4 bolt and nylock the centre-to-centre reach can be set anywhere from 54 to 116 mm.
Slotted 2-3 in Tub Overflow Cover Plate
This is a 92 mm round blank cover plate for a tub overflow. It replaces a cracked or discontinued trip-lever faceplate, or covers the hole after you switch to a toe-tap or lift-and-turn drain. Its slotted screw holes (5.5 mm wide, counterbored for pan heads) fit any screw spacing from 2 in (50.8 mm) to 3 in (76.2 mm). On the back, a 9 mm stand-off skirt with inlet notches at the bottom keeps the overflow path open. Print it in PETG, face-down.
Shower Curtain Splash Guard Clamp
A wall-mounted vertical channel that grips the edge of a shower curtain liner and holds it flat against the tile, so water runs down the inside instead of escaping onto the floor at the end of the tub. The 90 x 28 mm back plate stands 20 mm off the wall with an 86 mm long tapered slot (3.6 mm at the mouth, 1.4 mm at the base, 14 mm deep) that wedges any vinyl or fabric liner; two counterbored 4.5 mm holes take M4 or #8 anchors, and the flat back also suits a strip of VHB tape. Both ends of the channel are open so trapped water drains straight out the bottom.