Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
GT2 Toothed Belt Clamp Plate
This belt clamp plate is part of the 'NEMA17 Belt-Drive Camera Slider' kit. The 70 × 24 × 4 mm red plate clamps both ends of the 6 mm GT2 belt against the Quad LM8UU Camera Carriage's belt tab. A 7 mm band of 2.0 mm-pitch ridges (1.0 mm wide, 0.75 mm tall) meshes with the belt teeth so the belt can't slip. Four M3x12 screws pass through 3.4 mm holes on a 35 × 15 mm rectangle into the tab's M3 heat-set inserts. The holes sit above and below the belt band, so no screw goes through the belt.
MGN12H GT2 Belt Clamp Carriage
A 68 × 38 × 5 mm carriage plate that bolts straight onto an MGN12H block (20 × 20 mm M3 pattern, heads recessed in 6.2 mm counterbores) and clamps both ends of a 6 mm GT2 belt on 2 mm-pitch tooth ridges, held by a zip tie through the four 4 × 3 mm slots. Four M3 heat-set bosses (4.0 mm bore, 6 mm deep) on a 38 × 25 mm grid give a flat tool deck for a gantry head, sensor or gripper — the piece a linear-rail axis normally needs but the rail kit never includes.