Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Multimeter Belt Clip Strap Holster
A belt clip for a handheld multimeter. The meter sits on a cradle ledge with a 46 mm inside depth and is held by a 25 mm hook-and-loop strap threaded through two 26 x 4 mm slots, so it fits most handheld DMMs whatever their width. The 6 mm spring-tongue clip (narrowing to 3.5 mm at the bump) slides over belts up to 50 mm wide and about 3–5 mm thick, and it prints on its side so the clip flexes along the layers instead of peeling them apart.
HT Radio And Speaker-Mic Belt-Clip Dock
This desk dock is 140 x 80 mm and has two upright tongues. Your handheld radio and its speaker-mic hang on them by their own spring belt clips, so the dock doesn't depend on any one radio body size. The radio tongue is 4 mm thick (60 to 44 mm wide, 61 mm tall). The mic tongue is 3 mm thick (36 to 28 mm wide, 46 mm tall). Both have a lead-in at the top. A rear notch routes the mic cord, and four 4.5 mm holes let you screw the dock to a shelf or desk with M4 or #8 screws.
Twin Tape Measure Belt-Clip Wall Dock
A wall dock that holds two tape measures by their own belt clips. Each clip drops into a 6 mm deep slot behind a 32 mm wide, 5 mm thick tongue that stands in for your belt, so the tape hangs in front and lifts straight off. The plate is 90 x 80 mm and takes two countersunk #8 wood screws or M4 screws through 4.5 mm holes placed between the tongues. It prints standing up with no supports.