Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Brake And Fuel Line Snap Clamp
A snap-in routing clamp for hard lines. It holds two 3/16 in (4.76 mm) brake lines, one 5/16 in (7.94 mm) fuel line and one 3/8 in (9.53 mm) return line side by side, and bolts to a frame rail or firewall with a single M5 or #10 screw through a 5.5 mm hole. It's 73 x 19 x 12 mm and replaces the mismatched bulk P-clips you'd otherwise buy for custom car, ATV and equipment line runs.
Flagged: hydraulic brake system. Not for safety-critical use without independent engineering review.
Brake Line Roller Straightener Block
A five-roller straightening block for 3/16 in (4.76 mm) brake, fuel and copper-nickel line: three 624 bearings on the lower row and two offset above squeeze the tube to a 4.2 mm nip (0.56 mm set) so coiled line pulls through dead straight. 110 x 44 x 18 mm body with V-groove entry and exit guides, 3.4 mm self-tapping holes for M4x16 socket-head screws (the 7 mm head clamps only the bearing's inner race), and four 5.5 mm M5 holes to bolt it to the bench — or grip the 9 mm plate edges in a vise.
Flagged: hydraulic brake system. Not for safety-critical use without independent engineering review.