Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Cabinet Door Twin Cutting Board Holster
A screw-on holster for the inside of a cabinet door. It stores two cutting boards upright, each up to 20 mm thick, in two 22 mm drained pockets, and stands just 56 mm off the door. Print two (each is 30 mm wide by 90 mm tall) and space them under the boards. Mount with #6 wood screws (3.5 mm shank) or M4 screws through the 4.5 mm holes. The part prints on its side so every layer holds the full U profile, which keeps the board weight in the strong plane.
Dishwasher Pod Gravity Dispenser
This is a gravity-feed dispenser for dishwasher detergent pods that screws to the inside of a sink-cabinet door. You load pods from the open top and pull them out one at a time from the bottom slot. A 3 mm lip stops the bottom pod from sliding out when the door swings. The chute is 50 mm wide and has 40 mm of depth under the 45° front lips, so pods up to about 48 x 38 mm of any thickness fit. It holds 6–7 pods in a 55 x 160 x 54 mm body. It prints flat on its back with no supports and mounts with two #8 (4.2 mm) pan-head screws through 4.5 mm holes. Pods are a poisoning risk, so mount it high inside a child-latched cabinet.
Stand Mixer Attachment Wall Hook Rack
A 150 x 62 mm wall or cabinet-door rack with three rising 12 mm hook fins that hang a stand mixer's flat beater, whisk and dough hook by their open frames, with an 8 mm lip that keeps them from sliding off. It mounts with two #8 wood screws (4.8 mm clearance holes, 50 mm apart). It prints upright with the fins doubling as feet, so the hook arms take load inside the layers.
Cabinet Door Measuring Spoon Drop Rack
A 160 × 50 × 45 mm rack that screws to the inside of a cabinet door. It has six tapered slots (20 mm wide at the mouth, 12 mm at the root, 32 mm deep). You drop a spoon or scoop in handle-down and the bowl rests on the 5 mm shelf, so handles from about 10 to 18 mm wide all hang neatly. It mounts with two countersunk 4.5 mm holes for #6 wood screws (3.5 mm shank) or M4 screws, and gussets at each end stiffen the shelf.
Cabinet Door Foil Box Cradle
A screw-on cradle pair for the inside of a cabinet door. It holds a roll box of foil, cling film or parchment, lying on its side and ready to tear, so the boxes stop getting crushed in a drawer. The U-channel is 52 mm wide by 30 mm deep, with an end stop and a snap nub, and fits boxes up to 50 mm square. Each bracket takes two 4.5 mm screw holes for #6 or M4 pan-head screws, placed clear of the box; print one bracket as is and one mirrored in the slicer.
Cabinet Door Pot Lid Rack
A screw-on rack for the inside of a kitchen cabinet door that stands two pot or pan lids upright in a tapered capture slot, clearing them off the shelf and out of the sink cupboard. 30 mm deep x 38 mm tall x 72 mm wide; the slot narrows from 11 mm at the mouth to 4.5 mm at the bottom so it grips everything from a 2 mm steel lid rim to an 8 mm silicone-edged glass lid, and two 4.5 mm M4 clearance holes 48 mm apart take short #6 or M4 screws into the door.