Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
3 in To 96/128 mm Pull Upgrade Backplate
This backplate covers the old holes when you swap 3 in (76.2 mm) kitchen cabinet pulls for 96 mm or 128 mm pulls, so you don't have to fill and repaint the door. The plate is 160 x 32 x 3.5 mm with 4.5 mm clearance holes at 96 and 128 mm centres (they take M4 or #8-32 pull screws), and the V-notches on both edges line up with the door's centre line. It also works as the drilling template for the new holes.
96 mm Cabinet Bar Pull With M4 Inserts
A 124 mm bar pull for kitchen cabinets and drawers that fits the standard 96 mm hole spacing. It takes M4 brass heat-set inserts (5.5 mm bores, 10 mm deep), so you can replace one broken or discontinued handle without buying a whole matching set. It prints lying on its side, so the pulling load runs along the layers instead of across them, and it leaves a 22 mm deep finger gap behind a 10 x 14 mm grip bar.