Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Monitor Arm Zip-Tie Cable Saddle
A 34 x 30 x 36 mm cable saddle that replaces the snap-on cable covers that break off monitor arms. A 90° V-notch underneath sits on round arm tubes about 18–50 mm across or on flat-topped arms, and two 2.2 x 5.5 mm tunnels take standard zip ties up to 4.8 mm wide to strap it down. On top there are three snap-in channels: one 8.2 mm bore for an HDMI or DisplayPort cable and two 6.2 mm bores for USB-C or power leads, each with a mouth 1.2 mm narrower than its bore so the cable clicks in.
Pool Winter Cover Barbed Cable Cinch Clip
A 60 x 36 x 14 mm clip that replaces the cracked UV-brittle clips holding a winter pool cover to its perimeter cable. You fold the cover hem around the cable and push it into the barbed V-channel, which tapers from 10 mm down to 3 mm, so cable-and-hem bundles from about 3 to 9 mm thick lock in place. A 6 x 26 mm slot beside it takes an anchor strap, bungee hook or tie-down for straps up to 25 mm wide. The clip prints flat, so the pull on the strap stays in the layer plane.