Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Pi Zero Outdoor Sensor Node Gland Box
A wall-mount base tub for outdoor Home Assistant and garden sensor nodes. It measures 90 x 60 x 36 mm and has a 3 mm wall. Inside are Pi Zero standoffs on the 58 x 23 mm pattern with 2.9 mm M2.5 holes, counterbored from the back. Two 12.6 mm holes in the bottom wall take M12 or PG7 cable glands, so sensor leads come in from below and water runs away from them. There are four M3 heat-set insert bosses with 4.0 mm bores for the lid, a 3 mm flat rim for foam gasket tape, and slotted wall ears for #8 screws.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.
Bulkhead Cable Gland Clamp
A screw-tightened cord grip that bolts inside a project box and clamps a 4.5–7 mm round cable so pulls on the lead never reach the solder joints. The 7 mm bore has three grip ribs and a split jaw closed by one M3 x 25 screw with a captured M3 nut; the rear flange bolts down with two M3 screws on 26 mm centres. Overall 40 x 34 x 20 mm, prints flat with no supports.
Flagged: mains electrical wiring. Not for safety-critical use without independent engineering review.