Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Single-Gang Pre-Terminated Cable Pass-Through Plate
This single-gang wall plate (70 x 114 mm, the 2.75 x 4.5 in standard size) has a 28 x 20 mm port that a moulded RJ45 plug or F-connector can pass through. An 8 mm side slit lets you slip the plate over Cat6 or RG6 that is already pulled, so you don't have to cut off factory connectors. The screw holes are slotted 4.2 mm wide over 79.5–83.8 mm centres, which covers the standard 83.3 mm (3-9/32 in) spacing of US device boxes and low-voltage brackets with #6-32 screws.
Electric Shaver Wall Charging Cradle
This wall-mounted charging cup holds a Braun, Norelco or similar electric shaver or beard trimmer upright and plugged in, which clears the charging stand off the counter. The pocket is 64 x 46 mm and 47 mm deep, so it takes shaver bodies up to about 62 x 44 mm. A 10 mm cord slot runs through the floor and front wall so the charger plug comes up under the shaver. A 105 mm backplate takes three #8 (4.2 mm) or M4 screws through 4.5 mm holes.
22 mm Snap-In Step-Down Cable Grommet
A snap-in grommet for a 22 mm hole (the common step-drill size) in a project box, dash or panel wall up to 3 mm thick. It has a 36 mm flange, four barbed spring fingers and a knock-out membrane with score rings at 4, 7, 10 and 13 mm. Trim to the ring that matches your cable and you get a snug pass-through, not a loose hole.