Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Hose-Clamp Camp Chair Cup Holder
This cup ring clamps onto camp chairs, canopy legs, boat rails or wagon frames made from round tube between 16 and 32 mm. A 90° V-jaw centres the tube and a band tunnel takes a standard 8 mm or 12.7 mm worm-drive hose clamp or a zip tie. The 82 mm bore fits 66 mm cans and most tumblers, which sit on an 11 mm lip with an open 60 mm centre so rain drains straight through. Overall size is 136 x 88 x 40 mm.
Folding Leg Brace M5 Lock Sleeve
A 45 x 30 mm sleeve that slides over the folding steel leg brace on a patio table, camp table or chair. Once the leg is open, you tighten an M5 screw into a captive 8 mm hex nut and it clamps the brace straight, standing in for the snap-in lock tooth that broke and can't be bought on its own. The 22 x 8 mm channel takes flat straps up to about 21 mm wide and stacked straps plus rivet head up to 8 mm thick. It prints lying flat, so the bending load runs along the layers.
Lawn Chair Webbing End Anchor Clip
This clip replaces the broken end clip on the webbing of a folding aluminium lawn or camp chair. The frayed end of a 1 in (25 mm) strap up to 2 mm thick goes through a 27 x 2.4 mm slot. Two M3 self-tapping screws pinch the strap, and a #8 screw passes through the 5 mm centre hole into the tube. A 90° V-saddle on the back sits square on frame tubes about 19–32 mm across. The block is 36 x 22 x 34 mm, so a chair that is otherwise fine can be reused.