Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Set-Screw Ceiling Fan Chain Pull
This fluted bell-shaped pull is 22 mm across and 42 mm tall. It replaces the pull on a ceiling fan or lamp chain after the old one snaps off. Bead chain up to about 4 mm feeds through a 4.5 mm centre channel, and one side-entry M3 screw threads into a 2.6 mm self-tap hole to clamp it. A 7 mm × 12 mm pocket in the base hides the chain tail or an old connector.
Ceiling Fan Blade Balancing Clip
A slide-on balancing clip for fixing a wobbling ceiling fan. Its flexing jaws grip blade edges 4–7 mm thick, and a hex well holds a stack of M5 nuts (8 mm across flats) as trim weight. Clip it to one blade at a time and slide it along the blade until the wobble stops. The nut count tells you how much weight to fix permanently. It's 48 x 15 x 20 mm and the jaws are printed flat, so they flex along the layers, not across them.
Flagged: a sharp edge or blade. Not for safety-critical use without independent engineering review.