Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Two-Stroke Oil 50/40/32:1 Mixing Cup
This mixing cup measures 2-stroke oil for string trimmers, chainsaws and blowers. Its 56 mm bore has notches on the inside wall at volumes worked out from the cup's own size. The column on one side covers a 1 US gal can: 75.7, 94.6 and 118.3 mL for 50:1, 40:1 and 32:1. The opposite column covers a 5 L can: 100, 125 and 156 mL. One, two or three notches show the ratio. The cup is 86 x 61 x 74 mm, with a 45° braced D-handle and a V pour notch, so you never have to work out ounces at the fuel can again.
Small Engine Air Filter Cover Snap Latch
This screw-on replacement latch fixes chainsaw, blower and trimmer air filter covers whose molded snap tab has broken off. The 38 x 16 x 5 mm foot screws to the cover through two 4.5 mm M4 holes set 16 mm apart. You drill the cover where the hook reaches the housing. An 18 mm flex arm stands 3 mm off the housing to clear lips up to 3 mm deep, and a thumb tab at the end releases it.
Chainsaw File Four-Size Bench Caddy
Bench or wall caddy with stepped ribs that hold chainsaw round files upright, sorted by size: three wells each for 5/32 in (4.0 mm), 3/16 in (4.8 mm), 13/64 in (5.2 mm) and 7/32 in (5.5 mm) files. The wells are bored 0.6 mm oversize at 4.6/5.4/5.8/6.1 mm. A wide 8 x 30 mm slot takes a flat file or depth-gauge tool, and two 4.5 mm holes take #8 screws. The base is 112 x 72 mm, the ribs step up from 24 to 36 mm tall, and tick notches mark each size so worn and new files stop getting mixed up in the saw box.
Chainsaw Bar Nose Scabbard
A slip-on scabbard for the tip of a chainsaw bar. It covers the front 128 mm of a 14–18 in bar that stands up to 76 mm tall with the chain on. The channel inside is 12 mm wide, and crush ribs grip the cutters, so it also fits 0.325 in and 3/8 in chain kerfs. A 5 mm cord eyelet lets you tie it to the saw's handle. It replaces a lost or cracked OEM bar cover for storage and transport.