Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Flex-Arm Childproof Cabinet Hook Latch
A screw-in child-safety latch for cabinet doors with a face frame. It has an 84 mm flex arm that mounts to the back of the door and a 26 mm catch with a 7 mm drop lip that mounts under the face-frame rail. The door opens about 20 mm, then the 7 mm hook stops it until an adult presses the arm down. Both pieces print together on their sides, joined by a snap-off tab, so the arm bends along the layers instead of across them. Mounting holes are 3.9 mm, for #6 (3.5 mm) or M3 pan-head screws.
Clamp-On Table Corner Safety Guard
A childproofing corner guard for tabletops 10–30 mm thick. It covers the corner with a 3 mm cap and 5 mm bumper walls that have a 12 mm radius on the outside. An M4 thumbscrew in a brass heat-set insert (5.5 mm bore) clamps it from underneath, so it stays on where foam bumpers peel off, and it doesn't need drilling or adhesive. The whole guard is 55 x 55 x 55 mm. The under-jaw has 45° ramps, so it prints cap-down with no supports. Use an M4 x 25 screw for thick tops and an M4 x 40 screw for thin ones, and put a felt pad on the screw tip.
Slotted Furniture Anti-Tip Strap Anchor
A 90 x 34 mm furniture anti-tip anchor with one 50 mm slot and a 9.5 mm counterbore. Two #8 or #10 wood screws (4.2/4.8 mm) go in at any spacing up to about 45 mm, so it lines up with holes already in a dresser or bookcase back. The 25 mm webbing strap passes through a 26 x 4.5 mm slot and pulls along the plate, not across the layer lines. Print two: one for the furniture and one for the wall stud.