Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Clawfoot Tub Foot Draining Floor Coaster
This 90 mm floor coaster goes under a cast-iron clawfoot tub foot. Its 80 mm conical dish slopes from a 30 mm flat floor and centres any ball or claw foot with a 30–70 mm contact patch, so the foot can't scratch or rust-stain the tile or wood. Four 5 mm radial drain channels let shower splash run out of the dish instead of sitting around the iron, and the 3 mm solid floor spreads the tub's weight over 64 cm² of floor.
1/2 in EMT Clawfoot Shower Rod Drop Tee
A set-screw tee for DIY clawfoot tub shower curtain rods made from 1/2 in EMT conduit (17.9 mm OD). The horizontal curtain rail passes straight through an 18.3 mm bore, and the vertical ceiling drop sits 30 mm deep in a top socket. Three M4 self-tapping set screws (3.4 mm pilots) lock both tubes. The body is 50 x 28 x 60 mm, and the rail bore has a teardrop top so it prints without supports.