Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Strap-Hung Shower Head Descaling Soak Cup
A rigid 112 mm OD × 50 mm deep cup that holds about 440 ml of vinegar. It soaks a fixed shower head with a face up to about 100 mm without taking the head off the arm. Two side lugs have 22 × 5 mm slots for a 20 mm hook-and-loop strap, a rubber band or a cord that goes over the shower arm, so the cup self-centres under the head whatever the arm's angle. It replaces the leaky plastic-bag-and-rubber-band trick, and a notch in the rim lets you pour the vinegar back out cleanly.
Vacuum Attachment Three-Cone Wall Ledge
A wall-screwed ledge with three hollow tapered cones (37 mm at the base down to 29 mm) that hold vacuum crevice tools, dusting brushes and upholstery heads by their bore. One cone fits both the common 32 mm (1-1/4 in) and 35 mm wand bores from any brand. Overall it is 168 x 60 x 50 mm, with 56 mm cone spacing and two 5.5 mm holes sized for M5 or #8 pan-head screws.
Four-Radius Cast Iron Pan Scraper
This is a 90 x 70 mm pan scraper for cast iron and stainless cookware. The bottom 1.2 mm stays straight and the edge then bevels in to a 6 mm grip ring. One long straight edge cleans flat pan bottoms. The four corners have 2, 8, 16 and 28 mm radii, so the right one fits a grill-pan groove, a saucepan corner, a skillet wall or a dutch oven, and you can scrape stuck food off without steel wool. There is a 22 mm finger hole and a 7 mm hang hole. Use it only once the pan has cooled to warm (PLA softens around 60 °C), or order it in PETG.
32 To 35 mm Vacuum Wand Adapter
Fits a 32 mm vacuum wand to a 35 mm attachment. Both ends are tapered friction fits, so small differences between brands (Shark, Bissell, Hoover, Dyson-style) still seal. The socket tapers from 33.2 to 31.4 mm ID and takes a 32 mm male wand, stopping on an internal shoulder. The male spigot tapers from 35.8 to 34.0 mm OD and plugs into 35 mm tool sockets. The part is 85 mm long with a ribbed grip collar.
Wall-Mount Toilet Brush Drip Holder
A screw-to-the-wall toilet brush holster with an 80 mm ID x 77.5 mm deep cup (clears brush heads up to 75 mm) and a raised 13.5 mm drip pedestal with four drain notches, so the head dries above the water it sheds instead of sitting in it. The 46 x 92 x 5 mm back plate carries four 4.5 mm holes on a 34 x 64 mm rectangle for M4 screws or #8 (4.2 mm) drywall/tile anchors; overall 84 mm wide x 92 mm tall.