Heads up: many models on this page are AI-generated or uploaded untested. They may be misconfigured for the intended application — check the dimensions and tolerances, and verify or edit the model before printing or relying on it.*
Closet Rod Four-Hanger Cascade Drop Bar
This drop bar hooks straight over a closet rod and hangs four clothes hangers in a vertical cascade, so one spot on the rod holds four shirts. The 40 mm open hook fits 1-1/4 in (31.75 mm) and 1-3/8 in (35 mm) closet rods. The 22 x 6 mm bar is 177 mm tall overall, and its four 11 mm holes take wire or plastic hanger hooks up to about 10 mm thick. It prints flat, so the hanging load runs along the layers and can't split them apart.
Closet Rod Snap-On Belt And Tie Hanger
A belt, tie and scarf hanger with eight upturned hooks. Its C-ring snaps onto a 1-5/16 in (33.3 mm) wood closet rod or a 1 in schedule-40 PVC rod (33.4 mm OD). The 33.8 mm bore has a 31 mm snap mouth so the hanger turns freely on the rod but won't get knocked off. The part is 65 x 167 x 8 mm and prints flat, so belt loads bend the hooks along the layers rather than across them.
Shelf-Pin Mount 1/2 in EMT Rod Cup
This rod cup lets you add a hanging rail to a wardrobe or cabinet without drilling. It pins into the shelf-pin holes the cabinet already has. A 18.4 mm U-cup takes 1/2 in EMT conduit (17.9 mm OD), and two 5 mm steel pins or dowels, each 16 mm long, go through the 6 mm plate into the side panel. The lower hole is round. The upper hole is a slot that fits hole spacings of 1 in, 1-1/4 in and 32 mm. There is also a 4.5 mm hole for a #6 screw if the cabinet has no shelf-pin holes. Print two and cut the EMT to the inside width of the cabinet minus 13 mm.
Closet Rod End Socket Bracket
Replacement wall socket for a US-standard 1-5/16 in (33.34 mm) closet rod — 34.0 mm bore, ribbed cup on a 68 x 50 mm back plate, fixed with four #8 / M4 screws through 4.5 mm holes. A side buttress takes an M4 brass heat-set insert (5.5 mm bore) so the set screw locks the rod against sliding and also grips a smaller 1-1/4 in rod.